Even color and locked joints for your daily drive
Driveway Paver Sealing in Ponte Vedra Beach, FL
Request a free driveway paver sealing quote in Ponte Vedra Beach, or call (904) 694-6107.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Is my driveway in the area for paver sealing, and how fast do I hear back?
Yes, a local contractor can seal a paver driveway anywhere in Ponte Vedra Beach, FL, and you should hear back within 1 business day, often much sooner. A quote costs nothing and you can say no afterward. To get started, call (904) 694-6107.
Think about the view from the street, with tire lanes darker than the rest, joints sunk low and a few orange streaks along the edge. Driveway paver sealing evens that out, keeps the sand in the joints and makes oil easier to treat next time. A quote covers the washing, the joint sand and the coat, plus any low spots or roots that need repair first. Describe your driveway's size and age, and request a quote.
What does a driveway go through that a patio never does?
A driveway takes weight, heat and drips every day, so it wears out sealer faster than any other paved area. A Jacksonville company says a driveway carries a few tons each time a car pulls in. To plan around your own vehicles, call (904) 694-6107.
Weight on the joints
Cars and trucks press down on the same two lanes. Joints that lose sand let pavers settle, and settled pavers hold water.
Oil, rust and tire marks
Drips and hot tires leave marks that a contractor treats before any sealing. Deep stains may not fully lift.
Full sun on open lots
A driveway with no shade gets the most heat and light. A Ponte Vedra Beach company says sun and salt together leave pavers chalky and washed out.
Sprinkler spray on the edges
The University of Florida notes that most Florida well water carries high iron, and watering with it can leave orange staining on whatever it touches.
Low spots by the street
A Ponte Vedra Beach company says sinking pavers or a low spot where a driveway meets the road usually points to a base problem, not a sealer problem.
Tree roots under the apron
A Jacksonville company says roots that lift a section get repaired before sealing, since a coat would only preserve the bump.
How often should a Ponte Vedra Beach driveway be sealed?
Most driveways here call for a fresh look every two to three years. A Florida concrete company says driveways every 2 to 3 years, and a Ponte Vedra Beach company says sealing is due after more than about three. A film coat and a penetrating coat age differently, so ask which one is going on. For a read on the coat you have, call (904) 694-6107.
Wet look and semi-gloss
A Jacksonville company says 3 to 5 years for film-forming products, and says driveways wear faster than patios.
Natural or matte penetrating
The same company gives 5 to 7 years for penetrating products, with less sheen and a more natural look.
The water check
If water beads, the coat is still working. If it soaks in and darkens the pavers, it is time.
Washing in between
A Florida concrete company suggests washing once or twice a year between coats.
Which finish suits a driveway: natural, semi-gloss or wet look?
Wet look gives deeper color and a light sheen, while natural keeps the stone look. A Jacksonville company offers wet look, with deeper color and a light sheen, or a natural finish, and lists colored joint sand as an upgrade. To compare samples, request a quote.
Wet look
Deep, saturated color with a light sheen. A Jacksonville company says it can turn cloudy white if it goes onto damp pavers or goes on too thick.
Semi-gloss
A softer sheen between the two. Ask for a sample on your own pavers before you decide.
Natural or matte
The closest to bare pavers. Suits homes where the association prefers a quiet look.
How much does driveway paver sealing cost in Ponte Vedra Beach?
Most driveways cost between $450 and $5,000, depending on size, condition and how many steps you need. A basic wash is the low end, and a full clean, sand and seal is the high end. For a price on your own driveway, request a quote.
A St. Augustine area company puts typical driveways of 1,000 to 1,500 square feet at about $1,750 to $3,750, and a Florida concrete company averages pool deck and driveway sealing at $2,000 to $4,000. Leveling and re-basing, quoted at about $8 to $20 per square foot, is a separate job. To discuss your numbers, call (904) 694-6107.
| Driveway size | Cleaning only ($0.30 to $0.50) | Clean and re-sand joints ($0.75 to $1.00) | Clean, sand and seal ($1.75 to $2.50) |
|---|---|---|---|
| 600 sq ft | $180 to $300 | $450 to $600 | $1,050 to $1,500 |
| 1,000 sq ft | $300 to $500 | $750 to $1,000 | $1,750 to $2,500 |
| 1,500 sq ft | $450 to $750 | $1,125 to $1,500 | $2,625 to $3,750 |
| 2,000 sq ft | $600 to $1,000 | $1,500 to $2,000 | $3,500 to $5,000 |
Rates come from a St. Augustine area paver company that publishes $0.30 to $0.50 for cleaning only, $0.75 to $1.00 for cleaning and re-sanding, and $1.75 to $2.50 to clean, sand and seal, with stripping old sealer and restoring at $2.75 to $3.50. No page gives a rate for a driveway alone, so the table multiplies those published pieces by the driveway size. The same company says typical driveways of 1,000 to 1,500 square feet run about $1,750 to $3,750. A Jacksonville company lists a 600 square foot driveway at $900 to $1,500. Repairs and leveling cost extra.
What is the driveway sealing process from start to finish?
A good driveway job takes one to two working days and follows a set order, from checking the base to a final walk. A St. Augustine area company says projects usually run one to two working days. To ask about your date, call (904) 694-6107.
1. Inspect the surface
Sunken pavers, low spots, root lifts, old coatings and drainage get checked before anyone quotes the work.
2. Repair what is moving
Lifted or dipped sections are reset on a rebuilt base, because sealer locks in whatever is under it.
3. Cover the garage and beds
Door bases, walkways, cars out of reach and planting beds get protected from overspray.
4. Pre-treat oil and rust
Stains get cleaners made for pavers, and the driveway is washed with a wide fan tip so joint sand stays put.
5. Dry and re-sand
A Jacksonville company says joints are re-sanded before sealing, never after, once the surface is dry.
6. Seal in two coats
A Florida concrete company says most jobs use two coats, a penetrating coat and then a full coat. A recoat on a good surface may need only one.
7. Cure and clear the drive
Foot traffic is fine after a few hours and cars wait about a day or two, depending on the product and the weather.
When can I drive on my driveway again?
Park on the street for a day or two. A Jacksonville paver company says about a day, with foot traffic fine within a few hours. A St. Augustine area company says about 24 hours for light walking and about 48 hours for vehicles. When in doubt, take the longer wait. For help planning the week, call (904) 694-6107.
The first few hours
A Jacksonville company says foot traffic is usually fine within a few hours, depending on the sealer and the weather.
Day one
Light foot traffic is usually fine, according to the St. Augustine area company.
Day two
Cars can usually return, depending on the product and the weather.
Sprinklers and rain
Unilock says to shut off automatic sprinklers, since water on a fresh coat can leave white marks, and to look for 24 to 48 hours of clear weather.
Should I wait before sealing a brand new driveway?
Yes, new pavers need time first. Unilock says to wait 60 to 90 days, and a Jacksonville company says 30 to 60 days. A Florida concrete company says the wait can run from a few months to about a year while white haze clears. Old Ponte Vedra blocks keep being rebuilt, so new driveways are common here. Tell the contractor your install date when you request a quote.
White haze
Efflorescence is a mineral film that usually clears in 2 to 3 months and can take up to a year, says Unilock.
Sealing too early
Unilock says to wait until the haze has cleared before any coat goes on.
An existing coat
A new driveway may already carry a thin coat. A contractor should check what is on it before quoting.
Can my homeowner association tell me which driveway finish to choose?
Only if your rules say so. Under Florida law, an association can review the appearance of an improvement only where its declaration or published guidelines say so, or where that can be reasonably inferred. A denial must be in writing and name the specific rule. To pick a finish before you submit anything, call (904) 694-6107.
A natural or matte coat is the quietest option when the rules are strict. A wet look coat shows more. Bring samples when you request a quote.
What should I ask a driveway sealer before I agree to a quote?
Ask the questions below and get the answers on paper, so two quotes can be compared fairly. A written quote also settles what happens if rain delays the day. To work through them, call (904) 694-6107.
Is repair work included?
A St. Augustine area company prices leveling and re-basing separately, at about $8 to $20 per square foot.
Will stains be pre-treated?
A Jacksonville company pre-treats oil, tire marks and rust, and says deep stains may not fully lift.
How many coats go on?
A Florida concrete company says two coats is common, and a recoat on a good surface may need one.
What are the cure rules?
Ask how long cars stay off and whether sprinklers must be shut down.
Is stripping needed?
A failed coat can add $1 to $2 per square foot, according to a Jacksonville company.
Can I see a sample first?
Wet look and natural finishes look different on every paver color.
Which Ponte Vedra Beach areas and nearby towns are covered for driveway estimates?
Requests are welcome from Ponte Vedra Beach and every community below, each with its own page. Not sure your street qualifies? Call (904) 694-6107.
What do sealed paver driveways look like in Ponte Vedra Beach?
Questions about driveway paver sealing in Ponte Vedra Beach
How long do paver sealers last on a driveway?
Driveways wear out sealer sooner than patios. A Florida concrete company says every 2 to 3 years, and a Ponte Vedra Beach company says most driveways need attention after about three. A Jacksonville company puts wet look coats at 3 to 5 years and penetrating matte at 5 to 7.
Do I need to seal pavers in Florida?
You can leave them bare, but a driveway takes the most abuse on the property. Unilock says its pavers stay sound without sealer. What sealing adds is color that lasts, a barrier against oil and tire marks and joint sand that stays put through summer rain.
How much is sealant for pavers?
Product alone runs $80 to $150 a gallon, according to Unilock, and a gallon covers about 80 to 150 square feet depending on type. Most of the price of a job is labor and prep, which is why contractors quote by square foot instead.
Is it better to spray or roll paver sealer?
Pros often do both. A Jacksonville company says they spray, then back-roll so the sealer reaches the joints and does not puddle. Rolling after spraying also helps avoid streaks, according to Unilock.
What is the average cost to seal pavers in Florida?
Rates posted by Northeast Florida companies come to $1.50 to $2.50 for each square foot of cleaning, sanding and sealing. A St. Augustine area company posts $1.75 to $2.50. On a 1,000 square foot driveway, that comes to roughly $1,500 to $2,500.
How much should it cost to seal a paver driveway?
A 600 square foot driveway runs about $900 to $1,500 at the Jacksonville rate. A St. Augustine area company puts typical driveways of 1,000 to 1,500 square feet at about $1,750 to $3,750. Add $1 to $2 per square foot if old sealer must be stripped.
What are the downsides of sealing pavers?
The main one is repeating it every few years. A coat put on damp pavers can turn cloudy white, and Unilock says high gloss sealers can be slippery when wet. Sealing also does not fix sinking or lifted pavers, which need repair first.
How long should cars stay off a newly sealed driveway?
About a day, says a Jacksonville paver company, with foot traffic fine after a few hours. A St. Augustine area company asks for about 48 hours before vehicles. Pick the longer wait if rain is possible, and keep sprinklers off.
Can oil stains and tire marks come out of pavers before sealing?
Many lighten a lot, according to a Jacksonville company that pre-treats them, but deep stains may not come out fully. That is worth knowing before you choose a finish, since a wet look coat will make a leftover stain stand out.
What if my driveway has sunken spots or tree roots?
They get repaired first. Sealer locks in whatever is underneath, so a Jacksonville company resets sunken or lifted sections on a rebuilt base before sealing. A St. Augustine area company lists leveling and re-basing at about $8 to $20 per square foot.
Ready to price out your driveway?
Call or use the short form. A reply should arrive inside 1 business day, usually much sooner.
Free, no obligation